Concept Guide

173| ap lldp profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
power
Transmit the 802.3 Power Via media dependent
interface (MDI) TLV to show the power support
capabilities of the AP interface.
NOTE: This parameter is supported by the W-
IAP3WNP and W-AP130 Series only.
lldp-med-network-policy-profile <profile>
Specify the LLDP MED Network Policy profile to be
associated with this LLDP profile.
lldp-med-tlvs
Specify which of the following LLDP-MED TLVs the AP
will send in LLDP PDUs. The AP will not send any
LLDP-MED TLVs by default.
capabilities
Transmit the LLDP-MED capabilities TLV. The AP will
automatically send this TLV if any of the other LLDP-
MED TLVs are enabled.
inventory
Transmit the LLDP-MED inventory TLV.
NOTE: An AP can’t send this TLV unless it also sends
the LLDP-MED capabilities TLV.
network-policy
Transmit the LLDP-MED network-policy TLV.
NOTE: An AP can’t send this TLV unless it also sends
the LLDP-MED capabilities TLV.
optional-tlvs
Specify which of the following optional TLVs the AP
will send in LLDP PDUs.
capabilities
Transmit the system capabilities TLV to indicate
which capabilities are supported by the AP.
management-address
Transmit a TLV that indicates the AP’s management
IP address, in either IPv4 or IPV6 format.
port-description
Transmit a TLV that gives a description of the AP’s
wired port in an alphanumeric format.
system-description
Transmit a TLV that describes the AP’s model
number and software version
system-name
Transmit a TLV that sends the AP name or wired
MAC address.
receive
Issue this command to enable LLDP PDU reception.
This parameter is enabled by default.
transmit
Issue this command to enable LLDP PDU
transmission. This parameter is enabled by default.