Concept Guide

show crypto dp
show
show crypto dp [peer <source-ip>]
Descriptions
Displays crypto data packets.
Syntax
Parameter Description
dp
Shows crypto latest datapath packets. The output is sent to crypto logs.
peer <source-ip>
Clears crypto ISAKMP state for this IP.
Usage Guidelines
Use this command to send crypto data packet information to the controller log files, or to clear a crypto
ISAKMP state associated with a specific IP address.
Examples
The command show crypto dp sends debug information to CRYTPO logs.
(host) # show crypto
Datapath debug output sent to CRYPTO logs.
Related Commands
Command Description Mode
crypto isakmp
Use this command to configure Internet Key
Exchange (IKE) parameters for the Internet
Security Association and Key Management
Protocol (ISAKMP)
Enable and Config modes
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show crypto dp | 1410