Concept Guide

show ap debug radio-stats
show ap debug radio-stats {ap-name <ap-name>|ip-addr <ip-addr>} radio {0|1} [advanced]
Description
Show aggregate radio debug statistics of an AP.
Syntax
Parameter Description
ap-name <ap-name>
Show log information for an AP with a specific name.
ip-addr <ip-addr>
Show log information for an AP with a specific IP address by entering its IP
address in dotted-decimal format.
ip6-addr <ip6-addr>
IPv6 address of the Access Point.
radio {0|1}
Specify the ID number of the radio for which you want to view statistics.
advanced
Include this parameter to display additional radio statistics.
Example
The output of this command displays general statistics for the radio, as well as statistics for transmitted and
received frames.
(host) #show ap debug radio-stats ap-name AP12 radio 1
RADIO Stats
-----------
Parameter Value
--------- -----
------------------- General Per-radio Statistics
Total Radio Resets 0
Resets Beacon Fail 0
TX Power Changes 5
Channel Changes 2
Radio Band Changes 0
Current Noise Floor 95
11g Protection 0
------------------- Transmit specific Statistics
Frames Rcvd For TX 2452151
Tx Frames Dropped 1736429
Frames Transmitted 4247212
...
If you include the advanced option at the end of the show ap debug radio-stats command, the output of
this command will include all the following parameters, as well as additional information for the SNR, frame
counts, channel busy times, and data bytes for transmitted and received packets. If you omit the advanced
option, the output will include less information, and the data will be displayed in a different order. The
following table describes the output of this command when the advanced option is included.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug radio-stats | 1119