Concept Guide

1020| show ap config Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
The default setting for this
parameter is level 2.
When performance drops
due to interference from
non-802.11 interferers
(such as DECT or
Bluetooth devices), the
level can be increased up
to level 5 for improved
performance. However,
increasing the level makes
the AP slightly “deaf” to its
surroundings, causing the
AP to lose a small amount
of range.
The levels for this
parameter are:
l Level-0: no ANI
adaptation.
l Level-1: noise
immunity only.
l Level-2: noise and spur
immunity. This is the
default setting
l Level-3: level 2 and
weak OFDM immunity.
l Level-4: level 3 and FIR
immunity.
l Level-5: disable PHY
reporting.
Enable CSA
Displays whether or not
the AP has enabled
channel switch
announcements (CSAs)
for 802.11h.
CSA Count
Number of channel switch
announcements that must
be sent before the AP will
switch to a new channel.
Management Frame Throttle interval
Average interval that rate
limiting management
frames are sent from this
radio, in seconds. If this
column displays a zero (0)
rate limiting is disabled for
this AP.