Concept Guide

Table Of Contents
616 | wlan ssid-profile Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
Command/Parameter Description Range Default
auth-pkt-mac-format
{delimiter|upper-case}
Configures a delimiter and upper-case
characters in a MAC Address string of
authentication packet or the username and
password of the client.
The delimiter and upper-case parameters in
this command are available for all authentication
methods. And without the mac-authentication-
delimiter and mac-authentication-upper-case
configuration, it works on the username and
password for MACAuthentication.
auth-server <name>
Configures an authentication server for the SSID
users.
auth-survivability
Enables the authentication survivability feature.
NOTE: The authentication survivability feature
requires ClearPass Policy Manager 6.0.2 or later,
and is applicable only when external servers such
as RADIUS are configured for the SSID. When
enabled, Instant authenticates the previously
connected clients using EAP-PEAP authentication
even when connectivity to ClearPass Policy
Manager is temporarily lost. The Authentication
survivability feature is not applicable when a
RADIUS server is configured as an internal
server.
bandwidth-limit
<limit>
Configures an aggregate amount of bandwidth
that each radio is allowed to provide for the
connected clients.
1—65535
blacklist
Enables dynamic blacklisting of clients.
broadcast-filter
<type>
Configures broadcast filtering parameters:
You can configure any of the following filtering
parameters:
l All—When set to All, the W-IAP drops all
broadcast and multicast frames except DHCP,
ARP, igmp-group queries, and IPv6 neighbor
discovery protocol.
l ARP—When set to ARP, the W-IAP drops all
broadcast and multicast frames except ARP,
DHCP, igmp-group queries, IPv6 neighbor
discovery protocol, and additionally converts
ARP frames to unicast.
l Disabled When set to Disabled, the W-IAP
routes all the broadcast and multicast frames
to the wireless interfaces.
All, ARP,
Disabled
Disabled