Concept Guide

Command/Parameter Description Range Default
from which the rule applies.
<eport>
Specifies the ending port number until
which the rule applies
1-65534 —
dst-nat
Allows the W-IAP to perform
destination NAT on packets.
— —
src-nat
Allows the W-IAP to perform source
NAT on packets. When configured, the
source IP changes to the outgoing
interface IP address (implied NAT
pool) or from the pool configured
(manual NAT pool).
— —
<dst-nat-IP-address>
Specifies the destination NAT IP
address for the specified packets
when dst-nat action is configured.
— —
<dst-nat-port>
Specifies the destination NAT port for
the specified packets when dst-nat
action is configured.
— —
app <app>
Specifies a rule to allow or deny
access to a specific type of
application.
To view the list
of applications,
run the show
dpi app all
command.
—
appcategory <appgrp>
Specifies a rule to allow or deny
access to a specific category of
application.
To view the list
of application
categories, run
the show dpi
appcategory
all command.
—
webcategory <webgrp>
Specifies a rule to allow or deny
access to websites based on website
category.
To view the list
of website
categories, run
the show dpi
webcategory
all command.
—
webreputation <webrep>
Specifies a rule to allow or deny
access to websites based on security
rating.
l trustworthy-
sites
l low-risk-
sites
l moderate-
—
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide wlan access-rule | 597