Concept Guide

show l2tpv3 system
show l2tpv3 system statistics
Description
This command displays the L2TPV3 system statistics details.
Usage Guidelines
Use this command to view the tunnel and session statistics.
Example
The following example shows the output of the show l2tpv3 system statistics command:
(Instant AP)# sh l2tpv3 system statistics
L2TP counters:-
Total messages sent: 99, received: 194, retransmitted: 0
illegal: 0, unsupported: 0, ignored AVPs: 0, vendor AVPs: 0
Setup failures: tunnels: 0, sessions: 0
Resource failures: control frames: 0, peers: 0
tunnels: 0, sessions: 0
Limit exceeded errors: tunnels: 0, sessions: 0
Frame errors: short frames: 0, wrong version frames: 0
unexpected data frames: 0, bad frames: 0
Internal: authentication failures: 0, message encode failures: 0
no matching tunnel discards: 0, mismatched tunnel ids: 0
no matching session_discards: 0, mismatched session ids: 0
total control frame send failures: 0, event queue fulls: 0
Message counters:-
Message RX Good RX Bad TX
ILLEGAL 0 0 0
SCCRQ 0 0 1
SCCRP 1 0 0
SCCCN 0 0 1
STOPCCN 0 0 0
RESERVED1 0 0 0
HELLO 95 0 95
OCRQ 0 0 0
OCRP 0 0 0
OCCN 0 0 0
ICRQ 0 0 1
ICRP 1 0 0
ICCN 0 0 1
RESERVED2 0 0 0
CDN 0 0 0
WEN 0 0 0
SLI 0 0 0
The output of this command shows the system statistics such as total number of messages sent or received,
type of message, and so on.
Command History
Version Description
Dell Networking W-Series Instant
6.2.1.0-3.4
This command is introduced.
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide show l2tpv3 system | 445