Concept Guide

388 | show datapath Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
show datapath
show datapath {acl <ID>|acl-all|acl-allocation|acl-rule <rule>|acl-rule-
detail<acl>|bridge|dmo-session|dmo-station <mac>|mcast|nat-pool <ID>|route
session|statistics|user|vlan}
Descriptions
This command shows the system statistics for your W-IAP.
Syntax
Parameter Description
acl <ID>
Displays datapath statistics associated with a specified ACL.
acl-all
Displays datapath statistics associated with all ACLs.
acl-allocation
Displays ACL table allocation details.
acl-rule <rule>
Displays the name of the ACL.
acl-rule-detail <acl>
Displays the ACL rule details.
bridge
Shows bridge table entry statistics including MAC address, VLAN, assigned
VLAN, Destination and flag information for an AP.
dmo-session
Displays details of a DMO session.
dmo-station <mac>
Displays details of a DMO station.
mcast
Displays multicast table statistics for the W-IAP.
nat-pool <ID>
Displays the contents of the datapath NAT entries table. It displays NAT
pools as configured in the datapath. Statistics include pool, SITP start, SIP
end and DIP.
route
Displays datapath route table statistics.
session
Displays datapath session statistics.
statistics
Displays datapath station association table statistics.
user
Displays datapath user statistics such as current entries, pending deletes,
high water mark, maximum entries, total entries, allocation failures, invalid
users and maximum link length.
vlan
Displays VLAN table information such as VLAN memberships inside the
datapath including L2 tunnels which tunnel L2 traffic.
Usage Guidelines
Use the show datapath command to display various datapath statistics for debugging purposes