Concept Guide

show clients
show clients [<diff>| accounting <mac>| checksum <mac>| debug| roaming| status <mac>| wired
[debug]]
Description
This command displays details about the W-IAP clients.
Syntax
Parameter Description
<diff>
Displays difference summary of the client table since the specified interval.
accounting <mac>
Displays accounting information for a specific client MAC address.
checksum <mac>
Filters checksum errors for a specific client MAC address.
debug
Displays the W-IAP client configuration details, which can be used for
debugging purpose.
roaming
Displays information about roaming clients.
status <mac>
Displays the current status for a client based on the specified MAC address.
wired [debug]
Displays the list of clients connected to wired or Ethernet interface. You can
also use the optional debug parameter to view the end-to-end information of
the wired clients for debugging purpose.
Usage Guidelines
Use this command to view information about the W-IAP clients. The W-IAP client table provides basic
information about the clients. For detailed information of each client, use the required parameter and specify
the MAC address of the client.
Example
show clients and show clients wired
The following output is displayed for the show clients command:
Client List
-----------
Name IP Address MAC Address OS Network Access Point Channel
---- ---------- ----------- -- ------- ------------ -------
10.17.88.226 08:ed:b9:e1:51:7d Network1 d8:c7:c8:cb:d4:20 44+
Type Role Signal Speed (mbps)
---- ---- ------ ------------
AN admin1 51(good) 300(good)
Info timestamp :233732
A similar output is displayed for the show clients wired command.
The client list in the command output for both wireless and wired clients provides the following information:
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide show clients | 369