Concept Guide

Parameter Description
enet-wired-mac
Shows Wired MAC Addresses learned.
ids-state <type>
Shows IDS State.
pot-ap-list
Display the Potential AP table. The Potential AP table shows the following data:
l bssid: the AP’s Basic Service Set Identifier.
l channel: The AP’s current radio channel
l phy type: The radio’s PHY type. Possible values are 802.11a, 802.11a-HT-40,
802.11b/g, 802.11b/g-HT-20.
l num-beacons: Number of beacons seen during a 10-second scan
l tot-beacons: Total number of beacons seen since the last reset.
l num-frames: Total number of frames seen since the last rest.
l mt: Monitor time; the number of timer ticks elapsed since the first AP is
recognized.
l at: Active time, in timer ticks.
l ibss: Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the
bssid has detected an ad-hoc BSS (an ibss bit in an 802.11 frame).
l rssi: The Receive Signal Strength Indicator (RSSI) value displayed in the
output of this command represents signal strength as a signal to noise ratio.
For example, a value of 30 would indicate that the power of the received signal
is 30 dBm above the signal noise threshold.
pot-sta-list
Shows the Potential client table. The Potential Client table shows the following
values:
l last-bssid: the Last BSSID to which the client associated.
l from-bssid,
l to-bssid
l mt:Monitor time; the number of timer ticks elapsed since the first client is
recognized.
l it: Client Idle time, expressed as a number of timer ticks.
rogue-ap <mac>
Displays rogue APs information for the current W-IAP.
routers
Shows the Router MAC Addresses that were learned. The output of this
command includes the router’s MAC address, IP address and uptime.
scan-info
Shows scanned information for the W-IAP.
sta-list
Shows the configuration and status of monitor information of the W-IAP.
state
Shows the AP monitoring state.
stats
Shows the AP monitoring statistics.
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide show ap monitor | 333