Concept Guide

202 | rf dot11a-radio-profile Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | CLI Reference Guide
rf dot11a-radio-profile
rf dot11a-radio-profile
beacon-interval <interval>
csa-count <count>
dot11h
interference-immunity <level>
legacy-mode
max-tx-power <power>
min-tx-power <power>
max-distance <count>
spectrum-band <type>
spectrum-monitor
no…
Description
This command configures a 5 GHz or 802.11a radio profile for a W-IAP.
Syntax
Parameter Description Range Default
rf dot11a-radio-
profile
Enables the 5 GHz RF configuration sub-mode — —
beacon-interval
<interval>
Enter the Beacon period for the W-IAP in
milliseconds.
When enabled, the 802.11 beacon
management frames are transmitted by the
access point at the specified interval.
60-500 100
csa-count <count>
Configures the number of channel switching
announcements that must be sent before
switching to a new channel.
This allows associated clients to recover
gracefully from a channel change.
0-10 2
dot11h
Allows the W-IAP to advertise its 802.11d
(country information) and 802.11h (transmit
power control) capabilities.
— Disabled
interference-immunity
<level>
Configures the immunity level to improve
performance in high-interference
environments. You can specify any of the
following immunity levels:
l Level 0— no ANI adaptation.
l Level 1— Noise immunity only. This level
enables power-based packet detection by
controlling the amount of power increase
that makes a radio aware that it has
received a packet.
0-5 2