Concept Guide

379 | ClearPass Guest Setup Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide
9. Click Register Shared Device.
Testing
To verify the setup:
1. Disconnect your AppleTV and OSX Mountain Lion/iOS 6 devices if they were previously connected to the
wireless network. Remove their entries from the controller’s user table using these commands:
n Find the MAC address— show user table
n Delete the address from the table— aaa user delete mac 00:aa:22:bb:33:cc
2. Reconnect both devices. To limit access to the AppleTV, access the ClearPass Guest UI using either the
AirGroup admin or the AirGroup operator credentials. Next, navigate to List Devices > Test Apple TV >
Edit. Add a username that is not used to log in to the Apple devices in the Shared With field.
3. Disconnect and remove the OSX Mountain Lion/iOS 6 device from the controller’s user table. Reconnect the
device by not using the username that you added to the Shared With field. The AppleTV should not be
available to this device.
4. Disconnect the OSX Mountain Lion/iOS 6 device and delete it from the controller’s user table. Reconnect
using the username that was added to the Shared With field. The OSX Mountain Lion/iOS 6 device should
once again have access to the AppleTV.
Troubleshooting
Table 74: Troubleshooting
Problem Solution
Limiting devices has no effect. Ensure IPv6 is disabled.
Apple Macintosh running Mountain Lion can use
AirPlay but iOS devices cannot.
Ensure IPv6 is disabled.