Concept Guide

311 | Uplink Configuration Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide
l Huawei E1552 (SingTel)
l Huawei E1750 (T-Mobile (Germany))
l UGM 1831 (TMobile)
l Huawei D33HW (EMOBILE(Japan))
l Huawei GD01 (EMOBILE(Japan))
l Huawei EC150 (Reliance NetConnect+ (India))
l KDDI DATA07(Huawei) (KDDI (Japan))
l Huawei E353 (China Unicom)
l Huawei EC167 (China Telecom)
l Huawei E367 (Vodafone (UK))
l Huawei E352s-5 (T-Mobile (Germany))
l Huawei D41HW
l ZTE AC2726
The following table lists the supported 4G modems.
l Netgear U340
l Netgear Aircard 341u
l Fraklin Wireless u770
l Huawei 3276s-150
l MC551L
l Pantech UML295
l Pantech UML290
In the 6.4.0.2-4.1 release, all modems are detected automatically by the W-IAP.
When UML290 runs in auto detect mode, the modem can switch from 4G network to 3G network or vice-
versa based on the signal strength. To configure the UML290 for the 3G network only, manually set the USB
type to pantech-3g. To configure the UML290 for the 4G network only, manually set the 4G USB type to
pantech-lte.
Configuring Cellular Uplink Profiles
You can configure 3G or 4G uplinks using the Instant UI or CLI.
In the Instant UI
1. Click the System link at the upper right corner of the Instant main window. The System window is
displayed.
2. In the System window, click the show advanced settings link. The advanced options are displayed.
3. Click the Uplink tab.
4. To configure a 3G or 4G uplink, select the Country and ISP.
5. Click OK.
6. Reboot the W-IAP for changes to affect.
In the CLI
To configure 3G/4G uplink manually:
(Instant AP)(config) # cellular-uplink-profile
(Instant AP)(cellular-uplink-profile)# usb-type <3G-usb-type>
(Instant AP)(cellular-uplink-profile)# 4g-usb-type <4g-usb>
(Instant AP)(cellular-uplink-profile)# modem-country <country>