Concept Guide
285 | Services Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide
1. Click the More > Services link at the top right corner of the Instant main window. The Services window is
displayed.
2. Click the RTLS tab. The following figure shows the contents of the RTLS tab.
3. Under Aruba, select the RTLS check-box to integrate Instant with the W-AirWave Management Platform or
Ekahau Real Time Location Server.
Figure 78 RTLS Window
4. Specify the IP address and port to which the location reports must be sent.
5. Specify the shared secret key in the Passphrase text box.
6. Specify the frequency at which the Virtual Controller can send updates to the server. You can specify a value
within the range of 5-3600 seconds. The default value is 5 seconds.
7. Select the Include unassociated stations check-box to send reports on the stations that are not
associated to any W-IAP to the RTLSserver.
8. Click OK.
To configure third-party RTLS such as Aeroscout:
1. Select the Aeroscout check-box to send the RFID tag information to an AeroScout RTLS.
2. Specify the IP address and port number of the AeroScout server, to which location reports must be sent.
3. Select the Include unassociated stations check-box to send reports on the stations that are not
associated to any W-IAP to the Aeroscout RTLSserver.
4. Click OK.
In the CLI
To configure W-AirWave RTLS:
(Instant AP)(config)# airwave-rtls <IP-address> <port> <passphrase> <seconds> include-unassoc-
sta
(Instant AP)(config)# end
(Instant AP)# commit apply
To configure Aeroscout RTLS
(Instant AP)(config)# aeroscout-rtls <IP-address> <port> include-unassoc-sta
(Instant AP)(config)# end
(Instant AP)# commit apply