Concept Guide

Service
Category
Description
l Select Destination-NAT to allow changes to destination IP address.
l Select Source-NAT to allow changes to the source IP address.
The destination-nat and source-nat actions apply only to the network services rules.
Destination
Select a destination option for the access rules for network services, applications, and
application categories. You can allow or deny access to any the following destinations
based on your requirements.
l to all destinations— Access is allowed or denied to all destinations.
l to a particular server—Access is allowed or denied to a particular server. After
selecting this option, specify the IP address of the destination server.
l except to a particular server—Access is allowed or denied to servers other than the
specified server. After selecting this option, specify the IP address of the destination
server.
l to a network—Access is allowed or denied to a network. After selecting this option,
specify the IP address and netmask for the destination network.
l except to a network—Access is allowed or denied to networks other than the
specified network. After selecting this option, specify the IP address and netmask of the
destination network.
l to domain name—Access is allowed or denied to the specified domains. After
selecting this option, specify the domain name in the Domain Name text box.
l to master IP—Access is allowed or denied to the master IP address.
Log
Select this checkbox to create a log entry when this rule is triggered. Instant supports
firewall based logging function. Firewall logs on the W-IAPs are generated as security logs.
Blacklist
Select the Blacklist checkbox to blacklist the client when this rule is triggered. The
blacklisting lasts for the duration specified as Auth failure blacklist time on the
Blacklisting tab of the Security window. For more information, see Blacklisting Clients on
page 183.
Disable scanning
Select Disable scanning checkbox to disable ARM scanning when this rule is triggered.
The selection of the Disable scanning applies only if ARM scanning is enabled, For more
information, see Configuring Radio Settings on page 257.
DSCP tag Select the DSCP tag checkbox to specify a DSCP value to prioritize traffic when this rule is
triggered. Specify a value within the range of 0 to 63. To assign a higher priority, specify a
higher value.
802.1p priority Select the 802.1p priority checkbox to specify an 802.1p priority. Specify a value between
0 and 7. To assign a higher priority, specify a higher value.
Table 53: Access Rule Configuration Parameters
3. Click OK and then click Finish.
In the CLI
To configure access rules:
(Instant AP)(config)# wlan access-rule <access-rule-name>
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide Deep Packet Inspection and Application Visibility | 268