Concept Guide
(Instant AP)(inbound-firewall)# end
(Instant AP)# commit apply
Configuring Management Subnets
You can configure subnets to ensure that the W-IAP management is carried out only from these subnets. When
the management subnets are configured, Telnet, SSH, and UI access is restricted to these subnets only.
You can configure management subnets by using the Instant UI or CLI.
In the Instant UI
To configure management subnets:
1. Navigate to Security > Inbound Firewall. The Inbound Firewall tab contents are displayed.
Figure 44 FirewallSettings—Management Subnets
2. To add a new management subnet:
l Enter the subnet address in Subnet.
l Enter the subnet mask in Mask.
l Click Add.
3. To add multiple subnets, repeat step 2.
4. Click OK.
In the CLI
To configure a management subnet:
(Instant AP)(config) # restricted-mgmt-access <subnet-IP-address> <subnet-mask>
(Instant AP)(config) # end
(Instant AP)# commit apply
Configuring Restricted Access to Corporate Network
You can configure restricted corporate access to block unauthorized users from accessing the corporate
network. When restricted corporate access is enabled, corporate access is blocked from the uplink port of
master W-IAP, including clients connected to a slave W-IAP. You can configure restricted corporate access by
using the Instant UI or CLI.
In the Instant UI
To configure restricted corporate access:
1. Navigate to Security > Inbound Firewall. The Inbound Firewall (see Figure 44) tab contents are
displayed.
Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide Roles and Policies | 199