Concept Guide

751| rf dot11g-radio-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
is not compatible with the
Channel Reuse feature.
maximum-distance
Maximum distance between a
client and an AP or between a
mesh point and a mesh portal,
in meters. This value is used to
derive ACK and CTS timeout
times. A value of 0 specifies
default settings for this
parameter, where timeouts are
only modified for outdoor mesh
radios which use a distance of
16km.
The upper limit for this
parameter varies, depending
on the 20/40 MHz mode for a
2.4GHz frequency band radio:
l 20MHz mode: 54km
l 40MHz mode: 24km
Note that if you configure a
value above the supported
maximum, the maximum
supported value will be used
instead. Values below 600m
will use default settings.
0-24km
(40MHz
mode)
0-54km
(20MHz
mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate
limiting management frames in
seconds. Zero disables rate
limiting.
Note: This parameter only
applies to AUTH and
ASSOC/RE-ASSOC
management frames.
0-60 1 second
interval
mgmt-frame-throttle-limit
Maximum number of
management frames allowed
in each throttle interval.
NOTE: This parameter only
applies to AUTH and
ASSOC/RE-ASSOC
management frames.
0-999999 20 frames
per interval
mode
One of the operating modes for
the AP.
ap-mode