Concept Guide

Table Of Contents
663| pcap (deprecated) Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description
<target-ipaddr>
<target-port>
bssid
(Optional) Specify the BSSID of the Air Monitor interface for the PCAP session.
<bssid>
BSSID of the Air Monitor Interface, which is usually its MAC address.
channel
(Optional) Number of a radio channel to tune into to capture packets
clear
Clears the packet capture session.
pause
Pause a packet capture session.
resume
Resume a packet capture session.
start
Start a new packet capture session.
stop
Stop a packet capture session.
<am-ip>
IP address of the air monitor collecting packets.
<id>
ID of the PCAP session.
bssid
(Optional) Specify the BSSID of the Air Monitor interface for the PCAP session.
<bssid>
BSSID of the Air Monitor Interface, which is usually its MAC address.
Usage Guidelines
These commands direct a Dell air monitor to send packet captures to the Wildpacket’s AiroPeek monitoring
application on a remote client. The AiroPeek application listens for packets sent by the air monitor.
The following pcap commands are available:
Command Description
clear
Clears the packet capture session.
pause
Pause a packet capture session.
resume
Resume a packet capture session.
start
Start a new packet capture session.
stop
Stop a packet capture session.