Concept Guide

enable secret
enable secret
Description
This config mode command allows you to change the password for enable mode.
Usage Guidelines
Use this command to change the password for enable mode. To reset the password to the factory default of
“enable”, use the no enable command.
The password must not contain a space and special characters.
Example
The following example allows you to change the password for enable mode.
(host) #configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(host) (config) #enable secret
Password:******
Re-Type password: ******
(host) (config) #
Command History
Version Modification
ArubaOS 1.0 Command introduced
ArubaOS 3.3.2 Updated with restriction of the secret phase
Command Informatio
Platform License Command Mode
Available on all platforms Available in the base operating
system
Config mode on master or
local controllers
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide enable secret | 358