Concept Guide

2341| wlan ssid-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Description
This command configures an SSID profile.
Syntax
Description Range Default
<profile-name>
Name of this instance of the profile. The
name must be 1-63 characters.
— “default”
902il-compatibility-mode
(For clients using NTT DoCoMo 902iL
phones only) When enabled, the
controller does not drop packets from
the client if a small or old initialization
vector value is received. (When TKIP or
AES is used for encryption and TSPEC is
enabled, the phone resets the value of
the initialization vector after add/delete
TSPEC.)
NOTE: This parameter requires the
PEFNG license.
— disabled
a-basic-rates
List of supported 802.11a rates, in Mbps,
that are advertised in beacon frames and
probe responses.
6, 9, 12, 18,
24, 36, 48,
54 Mbps
6, 12, 24
Mbps
a-beacon-rate
Sets the beacon rate for 802.11a (use for
Distributed Antenna System (DAS) only).
Using this parameter in normal
operation may cause connectivity
problems.
default, 6, 9,
12,
18,24,36,48,
54 Mbps
minimum
valid rate
a-tx-rates
Set of 802.11a rates at which the AP is
allowed to send data. The actual transmit
rate depends on what the client is able to
handle, based on information sent at the
time of association and on the current
error/loss rate of the client.
6, 9, 12, 18,
24, 36, 48,
54 Mbps
6, 9, 12,
18, 24, 36,
48, 54
Mbps
advertise-ap-name
If enabled, APs that are part of this VAP
will broadcast the AP Name information
in the beacons frames.
— —
advertise-location
If enabled, APs that are part of this VAP
will broadcast their GPS coordinates in
the beacons and probe response frames
as part of a vendor-specific Information
Element.
— disabled
ageout
Time, in seconds, that a client is allowed
to remain idle before being aged out.
1000
seconds
auth-req-thresh
The SNR threshold below which incoming
authentication requests are ignored.
0-100 dB 0 dB