Concept Guide

221| ap system-profile Dell Networking W-Series ArubaOS 6.5.x| Reference Guide
Parameter Description Range Default
syscontact
SNMP system contact
information.
— —
telnet
Enable or disable telnet to the
AP.
— disabled
Usage Guidelines
The AP system profile configures AP administrative operations, such as logging levels.
Example
For deployments running ArubaOS 6.3.1.x-6.4.1.x, execute the following commands to configure the LACP
parameters (LMS IP and the GRE striping IP) on an AP system profile.
(host) (config) #ap system-profile LACP
(host) (AP system profile "LACP") #lms-ip 192.0.2.1
(host) (AP system profile "LACP") #gre-striping-ip 192.0.2.2
For deployments running ArubaOS 6.4.2.x and later, execute the following commands to configure LACP and
AP LACP LMS map information settings.
(host) (config) #ap system-profile LACP
(host) (AP system profile "LACP") #lms-ip 192.0.2.1
(host) (AP system profile "LACP") #exit
(host) (config) #ap-lacp-striping-ip
(host) (AP LACPLMSmap information) #striping-ip 192.0.2.2 lms 192.0.2.1
(host) (AP LACPLMSmap information) #aplacp-enable
For more information on configuring LACP support, including important pre-deployment considerations and
troubleshooting information, refer to the ArubaOS User Guide.
Command History
Release Modification
ArubaOS 3.0 Command introduced.
ArubaOS 3.2 Support for additional RTLS servers and remote AP enhancements was
introduced.
ArubaOS 3.3.2 The following parameters were introduced:
l Maintenance-mode parameter was introduced.
l Multiple remote AP DHCP server enhancements were introduced.
l Support for RFprotect server and backup server configuration was
introduced.
The mms-rtls-server parameter was deprecated.
ArubaOS 5.0 The master-ip, rfprotect-server-ip and rfprotect-bkup-server parameters
were deprecated.