Concept Guide

show ap remote debug anul-sta-entries
show ap remote debug anul-sta-entries {ap-name <ap-name>|ip-addr <ip-addr>}
Description
Displays a list of VAPs and stations stored in the AP’s datapath.
Syntax
Parameter Description
ap-name <ap-name>
Show LACP information for an AP with a specific name.
radio
Shows the radio ID. Valid values are 0 and 1.
ip-addr <ip-addr>
Show LACP information for an AP with a specific IPv4 address.
Example 1
Using the following example, for W-AP320 Series check LAG columns to see if any packets are dropped.
#show ap remote debug anul-sta-entries ap-name ap325
ANUL BSS Table for Radio 0
--------------------------
bssid num_stas data ready drops
----- -------- ----------------
AC:A3:1E:53:5C:F0 2 0
ANUL STA State
--------------
mac bssid aid data ready bss Drops LAG LAG drops
--- ----- --- ---------- --- ----- --- ---------
3C:A9:F4:24:B2:54 AC:A3:1E:53:5C:F0 2 Yes B 0 Yes 0
78:31:C1:BC:D6:12 AC:A3:1E:53:5C:F0 1 Yes B 0 Yes 0
The following parameters appear in the output of the show ap remote debug anul-sta-entries command,
and are useful for debugging purposes.
Parameter Description
bssid
The BSS Id of the VAP.
num_stas
Indicates the number of stations associated to a VAP.
data ready drops
Indicates the total packets received and dropped before clients were ready
to receive data packets.
ANUL STA State
mac
The MAC address of a client.
bssid
The BSS Id of the VAP that the client is associated to.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap remote debug anul-sta-entries | 1256