Concept Guide

show ap debug gre-tun-stats
show ap debug gre-tun-stats {ap-name <ap-name>| bssid <bssid>|ip-addr <ip-addr>|ip6-addr <ip6-
addr>}
Description
Shows GRE tunnel packet statistics of an AP.
Syntax
Parameter Description
ap-name <ap-name>
Shows GRE tunnel packets information for an AP.
bssid <bssid>
Shows GRE tunnel packets information for a specific Basic Service Set
Identifier (BSSID). The Basic Service Set Identifier (BSSID) is usually the AP’s
MAC address.
ip-addr <ip-addr>
Shows GRE tunnel packets information for an AP with a specified IP address
by entering an IP address in dotted-decimal format.
ip6-addr <ip-addr>
Shows GRE tunnel packets information for an AP with a specific IPv6 address.
Example
The output of this command shows GRE tunnel packets information for an AP named myAP.
(host) #show ap debug gre-tun-stats myAP
GRE HBT Tunnel Stats
--------------------
AP IP Controller IP Sent Count HBT Tx Seqnum Idle (secs) Rcvd Count HBT Rx
Seqnum Idle (secs)
----- ------------- ---------- ------------- ----------- ---------- ------------
- -----------
10.15.121.240 10.15.121.240 0 12025 0 1506655 12025
0
GRE Tunnel Packet Stats
-----------------------
MAC BSSID Tun Input In IP Frags To WLAN Idle (secs) Rate pps From WLAN Tun Output Out
IP Frags Idle (secs) Rate pps
--- ----- --------- ----------- ------- ----------- -------- --------- ---------- ---
--------- ----------- --------
Command History
Introduced in ArubaOS 6.3.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug gre-tun-stats | 1099