Concept Guide

Parameter Description
Last SNR
The last recorded signal-to-noise ratio.
Last SNR CTL0
The signal-to-noise ratio for the last received data packet on the primary
(control) channel 0. This parameter is only displayed for APs operating in 40
Mhz mode.
Last SNR CTL1
The signal-to-noise ratio for the last received data packet on the secondary
(control) channel 1. This parameter is only displayed for APs operating in 40
Mhz mode.
Last SNR CTL2
The signal-to-noise ratio for the last received data packet on the secondary
(control) channel 2. This parameter is only displayed for APs operating in 40
Mhz mode.
Last ACK SNR
Signal-to-noise ratio for the last received ACK packet.
Last ACK SNR CTL0
Signal-to-noise ratio for the last received ACK packet on the primary (control)
channel 0. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL1
Signal-to-noise ratio for the last received ACK packet on the primary (control)
channel 1. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR CTL2
Signal-to-noise ratio for the last received ACK packet on the primary (control)
channel 2. This parameter is only displayed for APs operating in 40 Mhz mode.
Last ACK SNR EXT0
Signal-to-noise ratio for the last received ACK packet on the secondary
(extension) channel 0. This parameter is only displayed for APs operating in 40
Mhz mode.
Last ACK SNR EXT1
Signal-to-noise ratio for the last received ACK packet on the secondary
(extension) channel 1. This parameter is only displayed for APs operating in 40
Mhz mode.
Frames Received
Number of frames received.
Rx Data Frames
Number of data frames received.
Null Data Frames
Number of null data frames received.
Rx Mgmt Frames
Number of management frames received.
PS Poll Frames
Number of power save poll frames received.
Rx <n> Mbps
Number of frames received at <n> Mbps, where <n> is a value between 6 and
300.
Tx WMM
Number of Wifi Multimedia (WMM) packets transmitted for the following
access categories. If the AP has not transmitted packets in a category type,
this data row will not appear in the output of the command.
Dell Networking W-Series ArubaOS 6.5.x | Reference Guide show ap debug client-stats | 1080