Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
the broadcast probe requests
sent by clients to search for the
available SSIDs and ignores
the probe request if required,
mac-authentication
Enables MAC authentication for
clients that use this SSID
profile.
— Disabled
mac-authentication-delimiter
<delim>
Allows you to set a delimiter
that can be used in the MAC
address string for MAC
authentication.
You can specify colon or dash
for delimiter. If the delimiter is
not specified, the MAC address
in the xxxxxxxxxxxx format is
used. If you specify colon for the
delimiter, the MAC addresses in
the xx:xx:xx:xx:xx:xx format are
used.
colon or dash —
mac-authentication-upper-case
Enables the W-IAP to use
uppercase letters in MAC
address string for MAC
authentication.
— —
max-authentication-failures
<limit>
Configures the maximum
number of authentication
failures to dynamically blacklist
the users.
The users who exceed the
number of authentication
failures configured through this
command are dynamically
blacklisted.
— —
max-clients-threshold
<threshold>
Configures the maximum
number of clients for a BSSID
on a WLAN.
0-255 64
multicast-rate-optimization
Allows the W-IAP to select the
optimal rate for sending
broadcast and multicast frames
based on the lowest of unicast
rates across all associated
clients.
When enabled, the multicast
— Disabled