Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
l ARP—When set to ARP, the
W-IAP drops all broadcast
and multicast frames
except ARP, DHCP, igmp-
group queries, IPv6
neighbor discovery
protocol, and additionally
converts ARP frames to
unicast.
l Disabled— When set to
Disabled, the W-IAP routes
all the broadcast and
multicast frames to the
wireless interfaces.
captive-portal
{<type>[exclude-uplink
<types>]
|external[exclude-uplink
<types>|
profile <name>[exclude-uplink
<types>]]}
Configures captive portal
authentication for the SSID.
If the external captive profiles
are created, you can specify
the profile name by using the
external and profile keywords
and associated parameters.
— —
You can also exclude an uplink
type for the captive portal based
SSID profiles. When an uplink
type is selected for the exclude-
uplink option, redirection to the
captive portal based on the type
of specified uplink is disabled.
3G,4G,
wifi,ethernet
—
content-filtering
Routes all DNS requests for the
non-corporate domains to
OpenDNS on this network.
— Disabled
deny-inter-user-bridging
Disables the bridging traffic
between two clients connected
to the same SSID on the same
VLAN. When inter-user bridging
is disabled, the clients can
connect to the Internet, but
cannot communicate with each
other, and the bridging traffic
between the clients is sent to
the upstream device to make
the forwarding decision.
— —
deny-local-routing
Disables the routing traffic
between two clients connected
to the same SSID on different
VLANs. When local routing is
disabled, the clients can
— —