Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
authentication methods. And
without the mac-
authentication-delimiter and
mac-authentication-upper-
case configuration, it works on
the username and password
for MACAuthentication.
auth-server <name>
Configures an authentication
server for the SSID users.
— —
auth-survivability
Enables the authentication
survivability feature.
NOTE: The authentication
survivability feature requires
ClearPass Policy Manager
6.0.2 or later, and is applicable
only when external servers
such as RADIUS are configured
for the SSID. When enabled,
Instant authenticates the
previously connected clients
using EAP-PEAP authentication
even when connectivity to
ClearPass Policy Manager is
temporarily lost. The
Authentication survivability
feature is not applicable when
a RADIUS server is configured
as an internal server.
— —
bandwidth-limit
<limit>
Configures an aggregate
amount of bandwidth that each
radio is allowed to provide for
the connected clients.
1—65535 —
blacklist
Enables dynamic blacklisting of
clients.
— —
broadcast-filter <type>
Configures broadcast filtering
parameters:
You can configure any of the
following filtering parameters:
l All—When set to All, the W-
IAP drops all broadcast and
multicast frames except
DHCP, ARP, igmp-group
queries, and IPv6 neighbor
discovery protocol.
All, ARP,
Disabled
Disabled