Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
following options:
l Log—Creates a log entry when
this rule is triggered.
l Blacklist—Blacklists the client
when this rule is triggered.
l Classify-media—Performs a
packet inspection on all non-NAT
traffic and marks the critical
traffic.
l Disable-scanning—Disables ARM
scanning when this rule is
triggered.
l DSCP tag—Specifies a DSCP value
to prioritize traffic when this rule is
triggered.
l 802.1p priority—Sets an 802.1p
priority.
l Application throttling: To set a
bandwidth limit based on
application, application category,
web category or website
reputation, you can configure
application throttling by using the
throttle-downstream and
throttle-up options. For example,
you can limit the bandwidth rate
for video streaming applications
such as Youtube or Netflix, or set a
low bandwidth for suspicious
websites.
vlan <vlan-id>
Configures an access rule for VLAN
assignment.
1-4093 —
no…
Removes the configuration — —
Usage Guidelines
Use this command to configure access rules for user roles, to create a captive-portal role, and to assign VLANs
for the clients.
If TCP and UDP uses the same port, ensure that you configure separate access rules to permit or deny access.
Example
The following example configures access rules for the wireless network:
(Instant AP)(config)# wlan access-rule WirelessRule
(Instant AP)(Access Rule "WirelessRule")# rule 192.0.2.2 255.255.255.0 match 6 4343 4343 log
classify-media