Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
src-nat
Allows the W-IAP to perform source
NAT on packets. When configured, the
source IP changes to the outgoing
interface IP address (implied NAT
pool) or from the pool configured
(manual NAT pool).
— —
<dst-nat-IP-address>
Specifies the destination NAT IP
address for the specified packets when
dst-nat action is configured.
— —
<dst-nat-port>
Specifies the destination NAT port for
the specified packets when dst-nat
action is configured.
— —
app <app>
Specifies a rule to allow or deny
access to a specific type of application.
To view the list
of applications,
run the show dpi
app all
command.
—
appcategory <appgrp>
Specifies a rule to allow or deny
access to a specific category of
application.
To view the list
of application
categories, run
the show dpi
appcategory all
command.
—
webcategory <webgrp>
Specifies a rule to allow or deny
access to websites based on website
category.
To view the list
of website
categories, run
the show dpi
webcategory all
command.
—
webreputation <webrep>
Specifies a rule to allow or deny
access to websites based on security
rating.
l trustworthy-
sites
l low-risk-
sites
l moderate-
risk-sites
l suspicious-
sites
l high-risk-
sites
—
permit
Creates a rule to allow the specified
packets.
— —
deny
Creates a rule to reject the specified
packets
— —
<option1…option9>
Allows you to specify any of the
— —