Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
set-vlan <attribute>
{equals|not-equals| starts-
with|
ends-with| contains}
<operator>
<VLAN-ID>| value-of}
Assigns a VLAN to the clients. The
first rule that matches the
configured condition is applied.
You can specify any of the following
conditions:
l contains—The rule is applied
only if the attribute value
contains the specified string.
l ends-with—The rule is applied
only if the attribute value ends
with the specified string.
l equals—The rule is applied
only if the attribute value is
equal to the specified string.
l not-equals—The rule is applied
only if the attribute value is not
equal to the specified string.
l starts-with—The rule is applied
only if the attribute value
begins with the specified string.
l value-of - This rule sets the
VLANto the value of the
attribute returned. To set a
user role, the value of the
attribute must already be
configured on the W-IAP.
— —
shutdown
Shuts down the admin status port up, down up
spanning-tree
Enables Spanning Tree Protocol on
the wired profile.
STP ensures that there are no
loops in any bridged Ethernet
network and operates on all
downlink ports, regardless of
forwarding mode. STP will not
operate on the uplink port and is
supported only on W-IAPs with
three or more ports. By default
Spanning Tree is disabled on wired
profiles.
— —
speed <speed>
Assigns a value for indicating
speed of client traffic based on the
capabilities of the client, the AP,
and the cable.
10,100,200, auto auto
switchport-mode <mode>
Defines the switchport mode for the
access, trunk trunk