Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Command/Parameter Description Range Default
ends-with| contains}operator>
<role>| value-of}
You can specify any of the following
conditions:
l contains—The rule is applied
only if the attribute value
contains the specified string.
l ends-with—The rule is applied
only if the attribute value ends
with the specified string.
l equals—The rule is applied
only if the attribute value is
equal to the specified string.
l not-equals—The rule is applied
only if the attribute value is not
equal to the specified string.
l starts-with—The rule is applied
only if the attribute value
begins with the specified string.
l value-of - This rule sets the
user role to the value of the
attribute returned. To set a
user role, the value of the
attribute must already be
configured on the W-IAP.
set-role-machine-auth
<machine-only><user-only>
Configures a machine
authentication rule.
You can assign different rights to
clients based on whether their
hardware device supports machine
authentication.
Machine authentication is only
supported on Windows devices, so
this can be used to distinguish
between Windows devices and
other devices such as iPads.
— —
set-role-mac-auth <mac-only>
Configures a MAC authentication
based user role.
— —
set-role-pre-auth <role>
Configures a pre-authentication
role to allow some access to the
guest users before the client
authentication.
— —
set-role-unrestricted
Configures unrestricted access
control.
— —