Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
snmp-server
snmp-server
community <string> host <ipaddr> version {1 <name> udp-port <port>}|{2c|3 <name> [inform]
[udp-port <port>]}
user <name> <auth-prot> <password> [<priv-prot> <password>
Description
This command configures SNMP parameters.
Syntax
Parameter Description Range Default
community
Sets the read-only community string. — —
engine-id
Sets the SNMP server engine ID as a hexadecimal number. 24
characters
maximum
—
host
Configures the IP address of the host to which SNMP traps
are sent. This host needs to be running a trap receiver to
receive and interpret the traps sent by the controller.
— —
version
Configures the SNMP version and security string for
notification messages.
— —
inform
Sends SNMP inform messages to the configured host. — disabled
udp-port
Indicates the port number to which notification messages are
sent.
— 162
user
Configures an SNMPv3 user profile for the specified
username.
— —
auth-prot
Indicates the authentication protocol for the user, either
HMAC-MD5-98 Digest Authentication Protocol (MD5) or
HMAC-SHA-98 Digest Authentication Protocol (SHA), and the
password for use with the designated protocol.
MD5/SHA SHA
priv-prot
Indicate the privacy protocol for the user, either Advanced
Encryption Standard (AES) or CBC-DES Symmetric Encryption
Protocol (DES), and the password for use with the designated
protocol.
AES/DES DES
Usage Guidelines
This command configures SNMP on the W-IAPs only.
Example
The following example configures an SNMP host and community string:
(Instant AP)(config)# snmp-server community user123
(Instant AP)(config)# snmp-server host 10.0.0.1 version 2c udp-port 162 inform