Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
show blacklist-client
show blacklist-client [config]
Description
This command shows the configuration details for blacklisting clients and lists the clients blacklisted by W-IAP.
Syntax
Parameter Description
config
Displays the parameters and values configured for manual or dynamic blacklisting of
clients.
Usage Guidelines
Use this command to view information about the clients blacklisted by a W-IAP.
Example
The following output is displayed for the show blacklist-client command:
Blacklisted Clients
-------------------
MAC Reason Timestamp Remaining time(sec) AP name
--- ------ --------- ------------------- -------
00:24:6c:ca:41:51 user-defined 14:46:18 Permanent -
The output of this command provides information on the MAC address of client that is blacklisted, the reason
for blacklisting, timestamp, the associated W-IAP name, and the duration until which the client is blacklisted.
The following output is displayed for the show blacklist-client config command:
Blacklist Time :3600
Auth Failure Blacklist Time :3600
Manually Blacklisted Clients
----------------------------
MAC Time
--- ----
00:24:6c:ca:41:51 14:46:18
Dynamically Blacklisted Clients
-------------------------------
MAC Reason Timestamp Remaining time(sec) AP name
--- ------ --------- ------------------- -------
Dyn Blacklist Count :0
The output of this command provides the following information:
Parameter Description
Blacklist Time
Indicates the duration in seconds since the blacklisting has been
triggered due to an ACL rule.
auth-survivability cache-time-
out
Indicates the duration in seconds after which the clients that exceed
the maximum authentication failure threshold are blacklisted.
Manually Blacklisted clients
Displays the details of clients that are blacklisted manually.