Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Column Description
cov-idx(Total)
Displays RF coverage details. The W-IAP uses this metric to measure RF
coverage. The coverage index is calculated as x+y, where “x” is the W-IAP’s
weighted calculation of the Signal-to- Noise Ratio (SNR) on all valid APs on a
specified 802.11 channel, and “y” is the weighted calculation of the W-IAPs SNR
detected by the neighboring APs on that channel.
intf_idx(Total
Displays channel interference details. The W-IAP uses this metric to measure
co-channel and adjacent channel interference. The Interference Index is
calculated as a/b//c/d, where:
l Metric value “a” is the channel interference the AP sees on its selected
channel.
l Metric value “b” is the interference the AP sees on the adjacent channel.
l Metric value “c” is the channel interference the AP’s neighbors see on the
selected channel.
l Metric value “d” is the interference the AP’s neighbors see on the adjacent
channel.
l To calculate the total Interference Index for a channel add “a+b+c+d”.
channel_pair
Displays the list of paired channels.
Pairwise_intf_index
Displays the pairwise interference index.
Interface Name
Displays the interface name.
Current ARM
Assignment
Displays the current ARM assignment details.
Covered channels
Displays the number of channels being used by the W-IAP's BSSID in the 2.4
GHz and 5 GHz bands.
Free channels
Displays the number of available channels in the 2.4 GHz and 5 GHz bands.
ARM Edge State
Displays the ARM Edge status. If ARM edge status is enabled, the ARM-enabled
W-IAPs on the network edge will not function as Air Monitors.
Last check
channel/pwr
Indicates the time since the channel and power assignment was verified.
Last change
channel/pwr
Indicates the time since the channel and power assignment was updated.
Next Check
channel/pwr
Indicates the next interval at which the channel and power assignment will be
verified.
Assignment Mode
Indicates if the ARM is assignment is applicable to a single band or dual band.
show ap arm scan-times
The show ap arm scan-times command shows the AM channel scan times for a W-IAP. The following
example shows the output of the show ap arm scan-times command:
Channel Scan Time
-----------------
channel assign-time(ms) scans-attempted scans-rejected dos-scans flags timer-tick
------- --------------- --------------- -------------- --------- ----- ----------