Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
show alert global
show alert global [count]
Description
This command displays the list of client alerts for a W-IAP.
Syntax
Parameter Description
<count>
Filters client alerts based on the specified number.
Usage Guidelines
Use this command to view the client alerts for a W-IAP. The client alerts occur when clients are connected to the
Instant network. Alerts are generated when a client encounters problems while accessing or connecting to the
W-IAP network.
Example
The show alerts global command displays information about the clients for which alerts (if any) are
generated. The following example shows the output for the show alerts global command when no client
alerts are generated.
Client Alerts
-------------
Timestamp Type MAC Address Description Access Point
--------- ---- ----------- ----------- ------------
The output of this command provides the following information:
Parameter Description
Timestamp
Displays the time at which the client alert was recorded.
MAC Address
Displays the MAC address of the client that caused the alert.
Description
Provides a short description of the alert.
Access Point
Displays the IP address of the W-IAP to which the client is connected.
Command History
Version Description
Dell Networking W-Series Instant
6.2.1.0-3.3
This command is introduced.