Reference Guide

0511587-03 | September 2014 Dell Networking W-Series Instant 6.4.2.0-4.1.1 | CLI Reference Guide
Parameter Description Range Default
configured client count.
l For Distributed, L3 mode, you
can configure any discontiguous
IP ranges. The configured IP
range is divided into multiple IP
subnets that are sufficient to
accommodate the configured
client count.
lease-time <lease_
time>
Defines a lease time for the client in
minutes.
— 720
option <option_type>
<option_value>
Defines the type and a value for the
DHCP option to use.
You can configure up to eight DHCP
options supported by the DHCP
server and enter the option value in ""
not exceeding 255 characters.
— —
option82 alu
Enables the DHCP Option 82 for the
Centralized,l2 DHCP scope to allow
clients to send DHCP packets with the
Option 82 string.
— —
reserve {first
<count>| last
<count>}
Reserves the first few and last few IP
addresses in the subnet.
— —
server-type <server_
type>
Defines any of the following DHCP
assignment modes:
l Distributed, L2
l Distributed, L3
l Local
l Local, L2
l Local, L3
l Centralized, L2
l Centralized, L3
distributed,l2,
distributed,l3,local,
local,l2,
local,l3,centralized,l2,
centralized,l3
local
server-vlan <idx>
Configures a VLAN ID for the DHCP
scope. To use this subnet, ensure that
the VLAN ID specified here is
assigned to an SSID profile.
1-4093 —
subnet <subnet>
Defines the network IP address — —
subnet-mask <subnet_
mask>
Defines the subnet mask for Local,
Local, L3, and distributed,l3 DHCP
scopes. The subnet mask and the
network determine the size of subnet.
— —