Deployment Guide

Amigopod 3.7 | Deployment Guide Administrator Tasks | 285
 To specify an IP address for the network interface, select Manually configure IP address. The
following form is displayed for IP address details.
The MTU field allows you to specify the Maximum Transfer Unit size in bytes for the network interface.
While standard Ethernet uses a MTU of 1500 bytes, you may find it necessary to reduce the MTU slightly in
some network topologies. The Amigopod Visitor Management Appliance uses a default MTU of 1476 bytes
unless otherwise specified in this form.
The Ethernet Settings field specifies the physical layer link parameters to use for this network interface.
You may select one of the following:
 Automatic uses link auto-negotiation to determine the best available speed. This is the recommended
setting.
 1000 Mbit, full duplex
 100 Mbit, full or half duplex
 10 Mbit, full or half duplex