Reference Guide
Dell PowerConnect W-AirWave 7.5 | Best Practices Guide AirWave and Dell PowerConnect W-Series Integration Strategies | 21
Figure 11 Verify IP Address on APs/Devices > Monitor Page
Verify that there is a SNMPv2 community string that matches the SNMP Trap community string on the
controller.
(Controller-Name) # show snmp community
SNMP COMMUNITIES
----------------
COMMUNITY ACCESS VERSION
--------- ------ -------
public READ_ONLY V1, V2c
(Controller-Name) # #show snmp trap-host
SNMP TRAP HOSTS
---------------
HOST VERSION SECURITY NAME PORT TYPE TIMEOUT RETRY
---- ------- ------------- ---- ---- ------- -----
10.2.32.4 SNMPv2c public 162 Trap N/A N/A
Verify that firewall port 162 (default) is open between AirWave and the controller.
Validate that traps are making it into AirWave by issuing the following commands from AirWave command line.
[root@AMP ~]# qlog enable snmp_traps
[root@AMP ~]# tail -f /var/log/amp_diag/snmp_traps
1241627740.392536 handle_trap|2009-05-06 09:35:40 UDP: [10.2.32.65]->[10.51.5.118]:-
32737 sends trap: DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (127227800) 14 days,
17:24:38.00 SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.2.1106 SNMPv2-SMI::enterprises.14823.2.3.1.11.1.1.60
= Hex-STRING: 07 D9 05 06 09 16 0F 00 2D 08 00 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.5.0 = Hex-STRING: 00 1A 1E 6F 82 D0 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.6.0 = STRING: dell-apSNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.1.0 = Hex-STRING: 00 1A 1E C0 2B 32 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.56.0 = INTEGER: 2 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.17.0 = STRING: dell-124-c0:2b:32 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.18.0 = INTEGER: 11 SNMPv2-
SMI::enterprises.14823.2.3.1.11.1.1.58.0 = STRING: http://10.51.5.118/screens/wmsi/
reports.html?mode=ap&bssid=00:1a:1e:6f:82:d0
Ensure you disable qlogging after testing as it could negatively impact AirWave performance if left turned on:
[root@AMP ~]# qlog enable snmp_traps
NOTE: You will see many IDS and Auth Traps from this command. AirWave only processes a small subset of these traps which
display within AirWave. The traps that AirWave does process are listed above.