Reference Guide

8 | Configuring AirWave for Global Dell PowerConnect W-Series Infrastructure Dell PowerConnect W-AirWave 7.5 | Best Practices Guide
 Dell PowerConnect W-ArubaOS 6.0.1 or later
 Access points - Dell PowerConnect W AP-105, AP-92, AP-93, AP-125, AP-124, AP-134, AP-135
 Controllers - Dell PowerConnect W 600 Series or 3000 Series
AirWave Setup
Follow these steps in AirWave:
1. Navigate to AMP Setup > General.
2. In the Additional AMP Services section, set Enable AMON Data Collection to Yes, as shown in Figure 5:
Figure 5 AMON Data Collection setting in AMP Setup> General
3. Select Save.
Controller Setup (Master And Local)
Use SSH to access the controller’s command-line interface, enter enable mode, and issue the following
commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP-IP>
(Controller-Name) (config) # write mem
NOTE: ArubaOS 6.0.1 can report RF utilization metrics, while ArubaOS 6.1 is necessary to also obtain classified interferer
information.
CAUTION: Enabling these commands on ArubaOS versions prior to 6.0.1.0 can result in performance issues on the controller. If
you are running previous firmware versions such as ArubaOS 6.0.0.0, you should upgrade to ArubaOS 6.0.1 (to obtain RF
utilization metrics) or 6.1 (to obtain RF utilization and classified interferer information) before you enter this command.