Release Notes

vrrp
vrrp <id>
advertise <interval>
authentication <password>
description <text>
ip address <ipaddr>
no...
preempt
priority <level>
shutdown
tracking interface {fastethernet <slot>/<port>|gigabitethernet <slot>/<port>}
{sub <value>}
tracking master-up-time <duration> add <value>
tracking vlan <vlanid> {sub <value>}
tracking vrrp-master-state <vrid> add <value>
vlan <vlanid>
vrrp ipv6 <id>
advertise <interval>
description <text>
ipv6 address <ipaddr>
no...
preempt
priority <level>
shutdown
tracking interface {fastethernet <slot>/<port>|gigabitethernet <slot>/<port>}
{sub <value>}
tracking master-up-time <duration> add <value>
tracking vlan <vlanid> {sub <value>}
tracking vrrp-master-state <vrid> add <value>
vlan <vlanid>
Description
This command configures the Virtual Router Redundancy Protocol (VRRP).
Syntax
Parameter Description Range Default
id
Number that uniquely identifies
the VRRP instance, also known as
the VRID. This number should
match the VRID on the other
member of the redundant pair.
For ease in administration, you
should configure this with the
same value as the VLAN ID.
After you configure the VRID, the
command platform enters VRRP
mode. From here, you can access
the remaining VRRP commands.
1-255 —
advertise
Specifies the time, in seconds,
between successive VRRP
advertisements sent by the
current master.
1-60
seconds
1 second
(1s=1000ms)
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide vrrp | 1978