Release Notes

1825 | show wlan dot11k-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
Advertise 802.11K Capability Shows if the profile has enabled or disabled the 802.11K feature.
Forcefully disassociate on-
hook voice clients
If enabled, the AP may forcefully disassociate clients that reach the
maximum CAC peak capacity or call handoff reservation.
Measurement Mode for
Beacon Reports
Shows the profile’s beacon measurement mode:
l active: In this mode, the client sends a probe request to the broadcast
destination address on all supported channels, sets a measurement
duration timer, and, at the end of the measurement duration, compiles all
received beacons or probe response with the requested SSID and BSSID
into a measurement report.
l beacon-table: In this mode, the client measures beacons and returns a
report with stored beacon information for any supported channel with the
requested SSID and BSSID. The client does not perform any additional
measurements. This is the default beacon measurement mode.
l passive: In this mode, the client sets a measurement duration timer, and,
at the end of the measurement duration, compiles all received beacons
or probe response with the requested SSID and BSSID into a
measurement report.
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master or local controllers.