Release Notes

Frame Retry Rate Low Watermark 8 %
The output of this command includes the following parameters:
Parameter Description
Detect Frame Rate
Anomalies
Shows of the profile enables or disables detection of frame rate anomalies.
Bandwidth Rate High
Watermark
If bandwidth in an AP exceeds this value, it triggers a bandwidth exceeded
condition. The value represents the percentage of maximum for a given
radio. (For 802.11b, the maximum bandwidth is 7 Mbps. For 802.11 a and g,
the maximum is 30 Mbps.) The recommended value is 85%.
Bandwidth Rate Low
Watermark
If an AP triggers a bandwidth exceeded condition, the condition persists
until bandwidth drops below this value.
Frame Error Rate High
Watermark
If the frame error rate (as a percentage of total frames in an AP) exceeds
this value, it triggers a frame error rate exceeded condition.
Frame Error Rate Low
Watermark
If an AP triggers a frame error rate exceeded condition, the condition
persists until the frame error rate drops below this value.
Frame Fragmentation Rate
High Watermark
If the frame fragmentation rate (as a percentage of total frames in an AP)
exceeds this value, it triggers a frame fragmentation rate exceeded
condition.
Frame Fragmentation Rate
Low Watermark
If an AP triggers a frame fragmentation rate exceeded condition, the
condition persists until the frame fragmentation rate drops below this value.
Frame Low Speed Rate High
Watermark
If the rate of low-speed frames (as a percentage of total frames in an AP)
exceeds this value, it triggers a low-speed rate exceeded condition.
Frame Low Speed Rate Low
Watermark
After a low-speed rate exceeded condition exists, the condition persists
until the percentage of low-speed frames drops below this value.
Frame Non Unicast Rate
High Watermark
If the non-unicast rate (as a percentage of total frames in an AP) exceeds
this value, it triggers a non-unicast rate exceeded condition. This value
depends upon the applications used on the network.
Frame Non Unicast Rate Low
Watermark
If an AP triggers a non-unicast rate exceeded condition, the condition
persists until the non-unicast rate drops below this value.
Frame Receive Error Rate
High Watermark
If the frame receive error rate (as a percentage of total frames in an AP)
exceeds this value, it triggers a frame receive error rate exceeded
condition.
Frame Receive Error Rate
Low Watermark
If an AP triggers a frame receive error rate exceeded condition, the
condition persists until the frame receive error rate drops below this value.
Frame Retry Rate High
Watermark
If the frame retry rate (as a percentage of total frames in an AP) exceeds
this value, it triggers a frame retry rate exceeded condition.
Frame Retry Rate Low
Watermark
If an AP triggers a frame retry rate exceeded condition exists, the
condition persists until the frame retry rate drops below this value.
Command History
This command was available in ArubaOS 3.0.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show rf event-thresholds-profile | 1646