Release Notes

159 | ap lldp profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
lldp-med-network-policy-profile <profile>
Specify the LLDP MED Network Policy profile to be
associated with this LLDP profile.
lldp-med-tlvs
Specify which of the following LLDP-MED TLVs the AP
will send in LLDP PDUs. The AP will not send any LLDP-
MED TLVs by default.
capabilities
Transmit the LLDP-MED capabilities TLV. The AP will
automatically send this TLV if any of the other LLDP-
MED TLVs are enabled.
inventory
Transmit the LLDP-MED inventory TLV.
NOTE: An AP can’t send this TLV unless it also sends
the LLDP-MED capabilities TLV.
network-policy
Transmit the LLDP-MED network-policy TLV.
NOTE: An AP can’t send this TLV unless it also sends
the LLDP-MED capabilities TLV.
optional-tlvs
Specify which of the following optional TLVs the AP will
send in LLDP PDUs.
capabilities
Transmit the system capabilities TLV to indicate which
capabilities are supported by the AP.
management-address
Transmit a TLV that indicates the AP’s management IP
address, in either IPv4 or IPV6 format.
port-description
Transmit a TLV that gives a description of the AP’s
wired port in an alphanumeric format.
system-description
Transmit a TLV that describes the AP’s model number
and software version
system-name
Transmit a TLV that sends the AP name or wired MAC
address.
receive
Issue this command to enable LLDP PDU reception.
This parameter is enabled by default.
transmit
Issue this command to enable LLDP PDU
transmission. This parameter is enabled by default.
transmit-hold <transmit-hold>
Enter a value from 1-100. This value is multiplied by
the transmit interval to determine the number of
seconds to cache learned LLDP information before
that information is cleared.
If the transmit-hold value is at the default value of 4,
and the transmit interval is at its default value of 30
seconds, then learned LLDP information will be
cached for 4 x 30 seconds, or 120 seconds.
transmit-interval <transmit-interval>
The interval between LLDP TLV transmission seconds.
The supported range is 1-3600 seconds and the
default value is 30 seconds.