Release Notes

261 | control-plane-security Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
control-plane-security
control-plane-security
auto-cert-allow-all
auto-cert-allowed-addrs <ipaddress-start> <ipaddress-end>
auto-cert-prov
cpsec-enable
no ...
Description
Configure the control plane security profile by identifying APs to receive security certificates.
Syntax
Parameter Description
auto-cert-allow-all
When you issue the control-
plane-security auto-cert-allow-
all command, the controller will
send a certificate to all associated
APs when auto certificate
provisioning is enabled. When
disabled, the controller sends
certificates only to APs whose IP
addresses are in the ranges
specified by auto-cert-allowed-
addrs.
auto-cert-allowed-addrs <ipaddress-start> <ipaddress-end>
Use this command to define a
specific range of AP IP addresses.
The controller will send
certificates to the APs in this IP
range when auto certificate
provisioning is enabled. Identify a
range by entering the starting IP
address and the ending IP address
in the range, separated by a single
space. You can repeat this
command as many times as
necessary to define multiple IP
ranges.
auto-cert-prov
Issue this command to enable
automatic certificate provisioning.
When this feature is enabled, the
controller will attempt to send
certificates to associated APs. To
disable this feature, use the
command no auto-cert-prov.
Automatic certificate provisioning
is disabled by default
cpsec-enable
Issue this command to enable
control plane security. To disable
this feature, use the command no
cpsec-enable. Control plane
security is enabled by default.