Release Notes

Parameter Description Range Default
uplink_load <speed>
The percentage of the WAN uplink that is
currently utilized. If no value is set, this
parameter will show a default value of 0
to indicate that the downlink speed is
unknown or unspecified.
1-100 0
(unspecified)
uplink_speed <speed>
Use the uplink <speed> parameter to
indicate the current WAN backhaul uplink
speed in Kbps. If no value is set, this
parameter will show a default value of 0
to indicate that the uplink speed is
unknown or unspecified.
0 -
2,147,483,647
kbps
0
(unspecified)
wan_metrics_link_status
Define the status of the WAN Link by
configuring one of the following values.
The default link status is reserved, which
indicates that the link status is unknown
or unspecified.
l link_down
l link_test
l link_up
l reserved
reserved
link_down
WAN link is down.
- -
link_test
WAN link is currently in a test state.
- -
link_up
WAN link is up.
- -
reserved
This parameter is reserved by the
Hotspot 2.0 specification, and cannot be
configured. This is the default link status.
- -
Usage Guidelines
The values configured in this profile can be sent in an ANQP IE to provide hotspot clients information about
access network characteristics such as link status and the capacity and speed of the WAN link to the
Internet.Issue this command without the <profile> parameter to display the entire WAN metrics profile list,
including profile status and the number of references to each profile. Include a profile name to display detailed
configuration information for that profile.
Examples
The example below shows that the controller has three configured WAN metrics profiles. The References
column lists the number of other profiles with references to the operator-friendly name profile, and the Profile
Status column indicates whether the profile is predefined. User-defined profiles will not have an entry in the
Profile Status column.
(host) (config) #show wlan hotspot h2qp-wan-metrics-profile
H2QP WAN Metrics Profile List
-----------------------------
Name References Profile Status
---- ---------- --------------
default 0
WanFastlink
Total:1
Command History
This command was introduced in ArubaOS 6.4.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide wlan hotspot h2qp-wan-metrics-profile | 2052