Reference Guide

411 | rf event-thresholds-profile Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Usage Guidelines
The event threshold profile configures Received Signal Strength Indication (RSSI) metrics. When certain RF
parameters are exceeded, these events can signal excessive load on the network, excessive interference, or faulty
equipment. This profile and many of the detection parameters are disabled (value is 0) by default.
Example
The following command configures an event threshold profile:
(host) (config) #rf event-thresholds-profile et1
detect-frame-rate-anomalies
Command History
This command was introduced in ArubaOS 3.0
Command Information
frr-high-wm If the frame retry rate (as a percentage of total frames in
an AP) exceeds this value, a frame retry rate exceeded
condition exists. The recommended value is 16%.
0-100 16%
frr-low-wm After a frame retry rate exceeded condition exists, the
condition persists until the frame retry rate drops below
this value. The recommended value is 8%.
0-100 8%
no Negates any configured parameter. — —
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
Parameter Description Range Default