Release Notes

993 | show ap debug radio-stats Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
Avail TX Buffers
An AP has a set number of buffers which it can use to buffer frames for
nonresponsive power save clients. The total number of buffer frames
depends upon the AP model type.
11g Protection
This parameter shows whether 802.11g protection has been enabled
or disabled.
Last TX Antenna
This parameter indicates whether the last frame transmitted was sent
on antenna 1 or antenna 0. This parameter can be useful for
troubleshooting external antennas.
Last RX Antenna
This parameter indicates whether the last frame received was via
antenna 1 or antenna 0. This parameter can be useful for
troubleshooting external antennas.
Scan Requests
Total number of scan requests received by the AP.
Scan Rejects
Total number of scan rejected by the AP.
Scan Rejects (Misc 1)
Number of scan rejects due to pending transmissions.
Load aware Scan Rejects
Load aware ARM preserves network resources during periods of high
traffic by temporarily halting scanning if the load for the AP gets too
high. The load aware Scan Rejects parameter shows the number of
times the AP has rejected a scan because of the load aware scan
feature.
PS aware Scan Rejects
If the ARM power-save aware scan feature is enabled, the AP will not
scan a different channel if it has one or more clients and is in power
save mode. The ps aware Scan Rejects parameter shows the number
of times the AP has rejected a scan because of the power-save aware
scan feature.
EAP Scan Rejects
If you enable the EAP-aware scanning feature in the AP’s ARM profile,
the AP will not attempt to scan a different channel if the Extensible
Authentication Protocol over LAN (EAPOL) exchange is in progress with
a client. This parameter shows the number of times the AP has rejected a
scan because of the EAP aware scanning feature.
Voice aware Scan Rejects
If you enable the VoIP Aware Scan feature in the AP’s ARM profile, the
AP will not attempt to scan a different channel if one of its clients has
an active VoIP call. This Voice aware scan Rejects parameter shows
the number of times the AP has rejected a scan because of the Voip
aware scan feature.
Video aware Scan Rejects
If you enable theVideo Aware Scan feature in the AP’s ARM profile, the
AP will not attempt to scan a different channel if one of its clients has
an activevideo session. This Video aware scan Rejects parameter
shows the number of times the AP has rejected a scan because of the
Video aware scan feature.
UAPSD Scan Rejects
Number of times the scan was rejected due to UAPSD-related trans-
missions.
Post radar related scan
Rejects
Number of times the scan was rejected due to recent radar detection.
CABQ traffic Scan Rejects
Number of times the scan was rejected due to pending multicast trans-
missions.