Release Notes

Parameter Description
l 20MHz mode: 54km
l 40MHz mode: 24km
Iff you configure a value
above the supported
maximum, the maximum
supported value will be
used instead. Values below
600m will use default
settings.
Spectrum Monitoring
When this parameter is
enabled, it turns an AP in
ap-mode into a hybrid AP.
An AP in hybrid AP mode
will continue to serve clients
as an access point while it
scans and analyzes
spectrum analysis data for
a single radio channel.
Assignment
Displays whether or not
ARM channel and power
assignment has been
enabled or disabled.
Allowed bands for 40MHz channels
Forty MHz channels may be
used on the specified radio
bands (802.11a or 802.11g).
Client Aware
Shows if the client aware
feature has been enabled
or disabled for this AP. If
enabled, AP will not change
channels when there are
active clients.
Max Tx Power
Maximum transmission
power for this AP, in dBm.
Min Tx Power
Minimum transmission
power for this AP, in dBm.
Multi Band Scan
Shows if the multi-band
scan feature has been
enabled or disabled on this
AP. If enabled, single-radio
APs will try to scan across
bands for Rogue AP
detection
Rogue AP Aware
Shows if the rogue AP
awareness feature has
been enabled or disabled
on this AP. If enabled, the
AP will try to contain off-
channel Rogue APs
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap config | 922