Release Notes

Column Description
AP Type
AP model type.
Flags
This column displays any flags for this AP. The list of flag abbreviations is also
included in the output of the show ap active command.
l 1 = 802.1x authenticated AP
l 2 = Using IKE version 2;
l A = Enet1 in active/standby mode
l B = Battery Boost On
l C = Cellular;
l D = Disconn. Extra Calls On
l E = Wired AP enabled
l F = AP failed 802.1x authentication
l H = Hotspot Enabled
l K = 802.11K Enabled
l L = Client Balancing Enabled
l M = Mesh
l N = 802.11b protection disabled
l P = PPPOE
l R = Remote AP
l S = AP connected as standby
l X = Maintenance Mode
l a = Reduce ARP packets in the air
l d = Drop Mcast/Bcast On
l u = Custom-Cert RAP
l r = 802.11r Enabled
Uptime
Number of hours, minutes and seconds since the last controller reboot or
bootstrap, in the format hours:minutes:seconds.
Outer IP
The outer IP address of a remote AP (RAP) is used to establish an IPsec VPN tun-
nel to the terminating master controller. The RAP acquires an outer IP address
from the locally connected network, usually via DHCP. (A RAP is typically behind a
NAT device whose public IPis seen as the outer ip for the RAP).
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 6.1 The parameter ip6-addr was added to view data for an IPv6 AP.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master
controllers
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap active | 852