Release Notes

ManualsBrandsDell ManualsTVs & monitorsW-620

741

742

743

744

745

746

747

748

749

750

749 | show aaa authentication-server radius Dell Networking W-Series ArubaOS 6.4.x| Reference Guide

Parameter Description

not receive a response before the message timed out.

NOTE: Timeouts include RADIUS accounting requests. Every request controller

sends to the RADIUS server is monitored for a timeout, so each retry

increments this counter.

AvgRspTme

Average response time. Time taken, on an average, for the RADIUS server to

respond to a message from the controller.

Tot Rq

Total errors. This counter reflects the total number of requests sent to the RADIUS

server (auth and accounting requests).

Tot Rsp

This counter reflects the total number of responses received by the RADIUS

server (auth and accounting responses).

Rd Err

Read errors. This counter reflects the total number of errors encountered while

reading off socket corresponding to that RADIUS server.

Uptime

Amount of for which the RADIUS server has been active/up. The RADIUS server

is considered to have an UP status if the server is active and serving requests.

The RADIUS server is considered to be DOWN if the server is not responding.

For example, if the RADIUS server does not respond for (<no of retries> *<

timeout>) seconds, the controller takes the RADIUS server down. It brings the

radius server back into service after the dead timeout.

SEQ

Information corresponding to the sequence number of requests. SEQ total cor-

responds to the total number of sequence numbers that can be used to com-

municate with the RADIUS server. SEQ free corresponds to the free/available/not

in use sequence numbers for a particular RADIUS server.

Command History

Version Description

ArubaOS 3.0

Command introduced.

ArubaOS 6.1

The Source Interface parameter was introduced.

ArubaOS 6.3 The enable-ipv6 and nas-ip6 fields were added to the output of this

command.

ArubaOS 6.4 The called-station-id parameter was added to the output of this command.

Command Information

Platforms Licensing Command Mode

All platforms Base operating system Enable or Config mode on master or

local controllers